Thingiverse
Nerf Longshot Jam Door
von WormPie
3
Downloads
1
Likes
0
Makes
Hello o/
We picked up an old Longshot in a bundle of other stuff, but the jam door was missing... how annoying ! Anyhoo, here's a quick replacement I whipped up in Tinkercad and printed on my Voxelab Aquila.
It was printed with a raft and supports, 50% infill, took about 3 hours. Filament is eSun Gold PLA+ which gives a surprisingly good colour match for this range of blasters and the plastic feels right.
No need to take anything apart for this one. Prime the longshot so that the black plastic lock drops and slide the door in over it. The whole door will then drop and snap into place.
Squeeze the sides of the replacement door gently together to help it snap in.
Byee :)
We picked up an old Longshot in a bundle of other stuff, but the jam door was missing... how annoying ! Anyhoo, here's a quick replacement I whipped up in Tinkercad and printed on my Voxelab Aquila.
It was printed with a raft and supports, 50% infill, took about 3 hours. Filament is eSun Gold PLA+ which gives a surprisingly good colour match for this range of blasters and the plastic feels right.
No need to take anything apart for this one. Prime the longshot so that the black plastic lock drops and slide the door in over it. The whole door will then drop and snap into place.
Squeeze the sides of the replacement door gently together to help it snap in.
Byee :)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
