Nerf Mega Bigshock Inline Magazine (inline clip)

This is a 4 shot inline mag for the Nerf Mega Bigshock. It allows you to put 3 short (3.5mm) darts in the mag and one in the barrel. To reload, tip the barrel down while priming and then fire away.

Materials:
This print
One 40mm length of 17/32 brass tube
Some tape or glue

First, you will need to take out the AR and dart post by whatever method you want but you will need a clear path to the back of the blaster. I used a flat head screwdriver to pry the cap on the back of the barrel off. If you are careful it can be glued back on or print and eventually, after test fitting all the parts, glue in one of these

https://www.thingiverse.com/thing:2235606
https://www.thingiverse.com/thing:1277598

Once you have a clear path to the back of the blaster you can test fit the print and use some tape to get an airtight seal and allow the print to seat all the way back. Also, make sure the sight is on top, and the channel lines up with the plunger tubes air hole.

The next step is