Nerf Modulus ECS10 Stockupgrade

The Nerf ECS-10 has one major design flaw, and that is the stock its to wobbly. So i decided to design a structure that gives it strength without disassembling the stock.

You just slide both peaces in between those two orange rods.
You align the printed parts together and press them in. It is a snug fit.
You do don't necessarly need screws but for securing reasons I used two M3x8 screws.
The screw Head shall not pass 3.5mm so it sits flat.

I printed it on my Ender3 V1 with 10% infill.
I used PLA for that piece.
Print Temp. 210°C
Bed Temp. 50°C

I hope you like my design!