Thingiverse
Nerf Roughcut 2x4 Trigger piece
von Humbujgej
0
Downloads
2
Likes
0
Makes
Had to design this after my original trigger snapped and epoxy failed too.
Dimensions to print in:
X: 87 mm
Y: 64 mm
Z: 11 mm
It's important to manually change these as not doing this may lead to incorrect prints which don't fit in your blaster.
May need some sanding if it doesn't fit.
Dimensions to print in:
X: 87 mm
Y: 64 mm
Z: 11 mm
It's important to manually change these as not doing this may lead to incorrect prints which don't fit in your blaster.
May need some sanding if it doesn't fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
