Nerf Stryfe 18650 Battery conversion

I didn't like the mods with the HUGE battery boxes sticking out of the sides. So I made this to keep the stryfe thin.

print the 2 parts to convert your Stryfe to use 18650 batteries.
You will need some snippers or dremel to cut the plastic so the batteries will fit.

1. Print out the 2 parts.
2. lift out the metal piece as shown. There are 4 metal prongs holding it in, you can use a knife to unwedge it
3. put the metal piece into the battery filler spacer piece.
4. Clear out the battery compartment by cutting out the extra plastics.
5. use a dremel to cut some plastic off the top of the compartment as shown, until the batters fit in flat.
6. if the battery does not connect, you can use a small piece of metal or magnet.
7. close it with the printed cover.