Slicer Discord
Nerf Stryfe upper lock blocking clamp – 3D-Druckmodell von Thingiverse Thingiverse

Nerf Stryfe upper lock blocking clamp

von VecteR
9 Downloads
4 Likes
0 Makes
Zum Modell
The NERF Stryfe has several internal locks that prevent firing e.g. without a magazine. One of those locks is in the upper receiver and prevents firing with an empty magazine. If a dart is in the magazine it pushed the lock up and you can fire. Sometimes older or aftermarket darts do not push the lock lever up.

Instead of removing the lock I installed this little clamp.

1. Remove screws and open Stryfe
2. Push lock in upper position
3. Insert clamp in the gap to prevent the lock to come down again.
4. Reassemble gun :)

Quelle
Thingiverse
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 1/3
Drucker
FDM / FFF
Dateiformat
STL
Material
Nachbearbeitung
Hardware
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen