Thingiverse
nerf two parts front grip angled
von GstoeGabs
85
Downloads
81
Likes
0
Makes
After searching for a picatinny compatible frontgrip for my metric version of the Lynx Blaster (https://www.thingiverse.com/thing:4661689), which won´t break due to extensive useage, i´ve come to the conclusion to design my own one...
Main features:
It´s split in two parts to make an aesthetic looking bi-coloured grip.
Slightly angled with about 20° backsweep for better ergonomics (and nice optic when used for the Lynx).
Print designed with loads in mind. e.g i´ve destroyed some of those usually vertically printed grips due to delamination. This one should be far more ridgid due to the orientation of the parts.
No need for supports. If your printer has troubles with bridging, then use the hi_support files. I´ve built in a little piece of removable support for easier printing. The grips shown in the foto are printed wihtout these part!
Should also be useable for imperial hardware. At least i´ve made a version using holes for #10-24 UNC and #8-32 UNC.
if you apprec
Main features:
It´s split in two parts to make an aesthetic looking bi-coloured grip.
Slightly angled with about 20° backsweep for better ergonomics (and nice optic when used for the Lynx).
Print designed with loads in mind. e.g i´ve destroyed some of those usually vertically printed grips due to delamination. This one should be far more ridgid due to the orientation of the parts.
No need for supports. If your printer has troubles with bridging, then use the hi_support files. I´ve built in a little piece of removable support for easier printing. The grips shown in the foto are printed wihtout these part!
Should also be useable for imperial hardware. At least i´ve made a version using holes for #10-24 UNC and #8-32 UNC.
if you apprec
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!