Thingiverse
NES Controller Stand
by diettelo
24
Downloads
16
Likes
1
Makes
NES Original Controller
I designed my own NES Controller stand for 2 Controllers.
It´s most for the 8bitdo Modkit to make them wireless.
I dont know if 8Bitdo NES Controller would fit.
Just check dimensions: 123,5 mm x 17,5 mm
If this is smaller than it will work for your Controller.
!!!! I printed this with a Resin Printer, the position i uploaded i printed from there on the fly!!!!
I dont know if it works on FDM Printer, HEX Walls are 1,5 mm thick and 3mm deph.
I designed my own NES Controller stand for 2 Controllers.
It´s most for the 8bitdo Modkit to make them wireless.
I dont know if 8Bitdo NES Controller would fit.
Just check dimensions: 123,5 mm x 17,5 mm
If this is smaller than it will work for your Controller.
!!!! I printed this with a Resin Printer, the position i uploaded i printed from there on the fly!!!!
I dont know if it works on FDM Printer, HEX Walls are 1,5 mm thick and 3mm deph.
diettelo also publishes on
18 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
