Thingiverse
Nespresso capsule wall holder
von nvsch
1
Downloads
6
Likes
0
Makes
Basically the design of the holder is the same as pumikachu's. Only a few adjustments to suit my needs.
- Added a 0.4mm layer to the back so I could glue them directly to the wall
- Added dovetail to the bottom piece for the label holder (Also included an STL without extra dovetail if you don't want to use labels)
- The label holder is smaller than RobotMama's, only 101,5mm in height where the original version was 150mm.
- Added a 0.4mm layer to the back so I could glue them directly to the wall
- Added dovetail to the bottom piece for the label holder (Also included an STL without extra dovetail if you don't want to use labels)
- The label holder is smaller than RobotMama's, only 101,5mm in height where the original version was 150mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
