Thingiverse
Nesting Threaded Voronoi Spheres
door DaveMakesStuff
72
Downloads
46
Likes
0
Makes
The sphere diameters are:
Small: 50 mm
Small Medium: 62.5 mm
Medium: 75 mm
Medium Large: 87.5 mm
Large: 100 mm
The pictures above show the small, medium small and medium spheres.
The threads print best when oriented at the top, but setting up proper supports in this position can be challenging.
You'll get good results by blocking supports for the top two-thirds of each hemisphere and using the "tree" supports in Cura with a bit of brim to hold it all together. You'll still need to do a bit of post-print clean-up.
Small: 50 mm
Small Medium: 62.5 mm
Medium: 75 mm
Medium Large: 87.5 mm
Large: 100 mm
The pictures above show the small, medium small and medium spheres.
The threads print best when oriented at the top, but setting up proper supports in this position can be challenging.
You'll get good results by blocking supports for the top two-thirds of each hemisphere and using the "tree" supports in Cura with a bit of brim to hold it all together. You'll still need to do a bit of post-print clean-up.
DaveMakesStuff publiceert ook op
7 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
