Net hook and wallplate

Net hook and ceiling plate. I broke my kid's plate for her faerie canopy net, which turns out is just a glorified mosquito net. Alas, I printed this and stuck some 3M command strips on it, and it holds perfectly fine. Fusion 360 model with some chamfers on the bottom of the plate to allow a 3M sticky thing to be pulled away.Some filets on the loop on the baseplate for strength.The overhang is a bit bad but acceptable. I didn't use support, and you should not need to either.the S hook is strong, and the top and bottom have been trimmed flat. All is printed in Sunlu white matte PLA, my fav filament.