Thingiverse
Netatmo Rain Gauge Mount
door GeoffB
39
Downloads
19
Likes
1
Makes
Here's a mount for your Netatmo rain gauge which enables it to be mounted onto a flat outdoor surface.
If the surface is not porous, print four of the shims to elevate the mount sufficiently to allow the waste water to escape.
You will need a 1/4" x 1/2" countersunk bolt to attach the gauge to the mount and 4 x 3/16" x 1" metal screws (or whatever is applicable). All fixings should be stainless steel.
The OpenSCAD file is here also in case you need to adjust anything.
If the surface is not porous, print four of the shims to elevate the mount sufficiently to allow the waste water to escape.
You will need a 1/4" x 1/2" countersunk bolt to attach the gauge to the mount and 4 x 3/16" x 1" metal screws (or whatever is applicable). All fixings should be stainless steel.
The OpenSCAD file is here also in case you need to adjust anything.
GeoffB publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
