Netatmo Sunshield

# Netatmo Sun Shield

The Netatmo outdoor module is supposed to be placed in a shady place with sufficient air flow for accurate readings. Ideally, it is placed high above the ground and not too close to buildings.

However, it's not always easy to find a spot where the sun is not shining at least at some times of the day. So we need to make our own shade, taking care that we don't block the air flow/convection.

This sun shield has an outer diameter of about 13cm, leaving around 2,5cm distance to the Netatmo module in order to avoid heat transmission (see cross-section image).

**Note: You need to provide an own adapter for mounting the shield to whatever suits you. The shield provides a central hole for a M6 screw at the bottom ring. The mounting foot in the images ia just an example for my very specific mounting situation and is not provided here.**

# Printing
You will need:

* 1x Bottom (no support needed)
* 3x Pillar (no support needed, print laying flat on its side