Thingiverse
Netgear GS105v5 Case
von reb1995
0
Downloads
0
Likes
0
Makes
Added manual supports in Cura for the mount points. Cleaned up the Otherwise printed with bridges. It is probably a couple mm too long front to back, but it mounts fine. it is 29 mm deep to accommodate the added 3 mm from the rubber feet.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
