Thingiverse
Netgear MS60/MR60 Wall Bracket
by iamthemoose
12
Downloads
10
Likes
0
Makes
Wall bracket/holder for the Netgear Mesh MS60 and MR60 router and satellites.
Prints well in basic PLA without supports. Adding supports will increase the quality of the hexagon cutouts, but will increase print time, cost and are not needed.
Could be scaled to fit the Netgear Orbi routers as well.
Prints well in basic PLA without supports. Adding supports will increase the quality of the hexagon cutouts, but will increase print time, cost and are not needed.
Could be scaled to fit the Netgear Orbi routers as well.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
