Thingiverse
Netgear Nighthawk M5 Wall Mount
by shanelord
11
Downloads
9
Likes
0
Makes
This is a wall mount bracket for the Netgear Nighthawk M5 (M5100/M5200)
I could only find M1 and M2 brackets and none were suitable for my needs. Designed this in Tinkercad.
M5 slips in the back into the pocket, then the rear spacer slips into the top to keep it lifted from the wall it is affixed to for air flow.
Created for a Prusa Mini+ and printed in black Prusament PETG at 0.25mm DRAFT, supports for the screw tabs and the bottom overhang along with a draft shield to ensure minimal deformation over the 5+ hour print.
I could only find M1 and M2 brackets and none were suitable for my needs. Designed this in Tinkercad.
M5 slips in the back into the pocket, then the rear spacer slips into the top to keep it lifted from the wall it is affixed to for air flow.
Created for a Prusa Mini+ and printed in black Prusament PETG at 0.25mm DRAFT, supports for the screw tabs and the bottom overhang along with a draft shield to ensure minimal deformation over the 5+ hour print.
shanelord also publishes on
26 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
