NetRametic - The Customizable and parametric Net

Hi everyone, I’ve seen many nets, but not a NETRAMETIC.If you want read all go to “reccomandation” at the end of description NETRAMETIC is a parametric two-layer grid for OpenSCAD (PMM/MakerWorld-ready). It generates:Bottom layer: vertical strands only.Top layer: horizontal strands only.Modes: Without_Frame (open edge) and Frame (adds a perimeter; top strands extend to the outer edge).Auto single-layer: if Spacing_Steps > 2.5, both directions are printed in the same layer (Z=0) for faster prints.Parameters (as shown in MakerWorld)Shape: Rectangle/Square, Circle, Triangle.Nozzle: 0.2, 0.4, 0.6 (strand width scales automatically as 2 × Nozzle).Spacing_Steps: slider [1:0.1:5] (pitch scales with nozzle so density stays proportional).Grid_Mode: Without_Frame | Frame.Circle: Radius.Rectangle/Square: Width, Height.Triangle: Base, Tri_Height (isosceles; the other sides are derived).Layer_Height: printing layer height used for the two layers (bottom at Z=0..H, top at Z=H..2H; unless single-laye