New Flite Test Firewall

Measured and mockup of the New FliteTest Firewall. This is the one used in the new mighty Mini Zero they recently released. I got to upload a edited one for the new Mighty mini Corsair, as the diameter is larger. but otherwise it's very close.

you may need to tap the motor holes with a drill to fit the motor to it, but I adjusted the model from the V1 that I made for myself so it *should* work if your printer is accurate.

The motor mounting plate mounts to the rear backplate using the spare longer servo screws included with all their A and F packs (the 5g servo's) any self tapping screw about or over 2mm should work however.


As always, please share your makes and provide feedback!

And as for how I have a scratch built model before the plans were released? I traced the kit onto some spare foam-board so I could build one from scratch! (these models CAN use the old style mini motor pod however!)


This is a close measurement of FliteTest's design and all rights go to th