(New version) Flashforge Adventure 5M Spool Holder

This is a spool holder for the Flashforge Adenturer 5M because the spool holder it comes with it awful and doesn't even keep the spool from sliding off.

This is an update on my previous design for this holder. The spool holding part is shifted 4cm or so to the side to reduce the stress on filament from spools that are close to empty. I'm publishing it separately since the other one still works and requires less filament.

It is designed to be screwed onto the top of the machine using two screws that are already in place on the frame. On the top of the printer just above where the original spool holder is supposed to mount, there are two screws that are 29.5mm apart (on center) and about 22mm from the edge. Unscrew those screws, screw them into the printed object's holes until they just start to come out the other side, place it back on the printer, and then tighten.
This updated version of the model also has a tiny tab designed to fit into a slot on the A5M's frame for improved alignm