Nextion 10.1" Enclosure

After upgrading my IoT display from an enclosed 7" Nextion to the 10.1" that does not come with an enclosure, nor does Itead even sell one, I needed something to protect the screen.

The pdf with dimensions from Nextion,(which I have included), was a starting point but certain things did not match exactly with my screen.

There was no way that I could print in one go as my print bed is smaller than the length of the screen, so I needed to design a more modular enclosure.

All parts were able to be printed on a 220mm x 220mm bed.

I assembled the parts carefully around the screen using super glue & then plastic weld solvent on the joins after masking off the glass on the screen but using the screen as a former.
I didn't want to glue everything up without the screen in place as this allowed for fine tuning of the fit.
All gluing & solvent weld was used in unseen areas at the back & I did only 1 side at a time & waited for it to cure before proceeding, plus also keep a descent w