Thingiverse
NexTool Knight Multitool Thumb Stud
door sclebo05
0
Downloads
1
Likes
0
Makes
I purchased a NexTool Knight multitool, and wished that it came with a thumb stud, and created this in Onshape. Makes one handed operation much easier.
Print upright, supports are probably not required. I gave it plenty of walls for strength. I used a two-part epoxy to glue this piece into the existing slot.
Print upright, supports are probably not required. I gave it plenty of walls for strength. I used a two-part epoxy to glue this piece into the existing slot.
sclebo05 publiceert ook op
1 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
