Thingiverse
Nexus 5 Wireless Charging Stand
von kalzenith
1
Downloads
3
Likes
0
Makes
This stand is intended to hold an LG Nexus 5 in portrait mode. You can glue a wireless charger circuit board/coil in the rear cavity, then glue the back plate on. There is about 7mm or 8mm of clearance for the circuitry.
(Warning: I haven't had a chance to print this yet to see if it works.)
(Warning: I haven't had a chance to print this yet to see if it works.)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
![Wireless charging cradle [Nexus 5]](/imgproxy.php?url=https%3A%2F%2Fcdn.thingiverse.com%2Frenders%2Fd3%2Fa3%2F80%2F8e%2F0e%2FIMG_4027_display_large.jpg&w=400&h=300)
