Thingiverse
Nexus Pro Spring Rest
by Blue_Mando
48
Downloads
27
Likes
1
Makes
This is a spring rest for the Adventure Force Nexus Pro.
Print with 1mm walls (minimum) and as high an infill as you deem necessary; I used 30% for mine.
Flip it 180 degrees if you don't want to use supports.
This is intentionally a very tight fit and may need a bit of adjustment once printed. On my print it needed to just be twisted back and forth a few times to wear it a little and slide on. You may need to sand it depending on printer/settings/thermal expansion/contraction of the print!
This rest netted a 20+ FPS increase using long darts as a test 150ish was baseline now hitting 172+.
Print with 1mm walls (minimum) and as high an infill as you deem necessary; I used 30% for mine.
Flip it 180 degrees if you don't want to use supports.
This is intentionally a very tight fit and may need a bit of adjustment once printed. On my print it needed to just be twisted back and forth a few times to wear it a little and slide on. You may need to sand it depending on printer/settings/thermal expansion/contraction of the print!
This rest netted a 20+ FPS increase using long darts as a test 150ish was baseline now hitting 172+.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
