NiftyCASE Front Panel Mults/Mods

I modified my NiftyCASE to have a buffered and passive mult on the front panel to save 4hp. I added a small jumper power cable that splits the flying bus cable to get an extra slot, but you may be able to use an existing plug.

These are all templates for drilling and painting on labels if you paint the case. I used intellijel passive and buffered. Included are options for one or two rows, and both buff, mult, or one of each.

https://intellijel.com/shop/eurorack/buff-mult/
https://intellijel.com/shop/eurorack/mult/

1. For the drill templates, **Mult_Hole_Guide** is for one row and **Mult_Hole_Guide_2_Row** is for two rows. Tape down and optionally mark the hole outlines. The **Mult_Hole_Punch_Guide** fits into the holes and guides a hole punch to the center of the hole. Shorter end goes in the stencil holes, longer end guides the punch shaft. I used this punch: https://www.amazon.com/gp/product/B008DXYOLC/

2. Drill a small pilot holed using the punch mark and then the ~6mm