Night Light Display Base

I use Petg filament.
Assemble is done using 3mmx12mm hex head screws with nylon lock nuts holding legs.
Light socket is designed around, https://www.amazon.com/dp/B08XXC8HJF?ref=ppx_yo2ov_dt_b_fed_asin_title
Rocker Switch can be found, https://www.amazon.com/dp/B07S1MV462?ref=ppx_yo2ov_dt_b_fed_asin_title
Note: I use hot glue on back side of rocker switch in a couple places for added holding.
Lamp cord, https://www.amazon.com/dp/B082QVPX67?ref=ppx_yo2ov_dt_b_fed_asin_title
Note: A couple small cable ties helps keep cord from being pulled through cord plate.
Depending on the size of the lithophane night light you may want to use different size bulbs.
Some suggestions: https://www.amazon.com/dp/B0CM8XHF7V?ref=ppx_yo2ov_dt_b_fed_asin_title
https://www.amazon.com/dp/B0BX9K43TH?ref=ppx_yo2ov_dt_b_fed_asin_title