MakerWorld
Electronics
Go to Model
Nightstand Maglock Mount
0
Downloads
1
Likes
0
Makes
I liked my Mag Lock style charger in my vehicle so much I wanted one for my nightstand. This allows you to mount a Mag Lock style charger onto a standard 7mm ball for your phones overnight charging. I used simple 1" sheetrock screws to screw it to my nightstand. In my .3mf file I've added a modifier for the neck and ball area that increases the wall count to 10 walls which makes it even stronger. Be carful when tightening the ball mount holder, you can break the neck. Once it's installed it's very solid.My initial prototype was made with ABS (that's what's in the pictures). I had some Bambu PA6-GF sitting around so I dried it and made another out of that. It's very strong. I can hold the Maglock Mount and move the nightstand around with it.Since this is an indoor item, PLA should do just fine. I would print it with about 6 to 8 walls though. But that's probably overkill.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
