Thingiverse
Nikon SB600 Flash Bounce / Diffuser
von jolars
139
Downloads
121
Likes
1
Makes
I used to tape a playing card to my flash to bounce light at my subject. That was before I got a 3D printer!
This is my first bounce card and will probably get some revisions as I get some time with it.
Slides onto my flash and holds on pretty good - I don't think any adhesives will be necessary to keep this seated.
Prints without supports on my PrintrBot Simple Metal in PLA at .2mm layers
This is my first bounce card and will probably get some revisions as I get some time with it.
Slides onto my flash and holds on pretty good - I don't think any adhesives will be necessary to keep this seated.
Prints without supports on my PrintrBot Simple Metal in PLA at .2mm layers
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
