【Nimbus】Modified Design - A1mini - Bottom Drawer

感谢原作者“JAV-3D”设计了底部如此精确的模型stp文件，让我省去不少手工测量校准的时间，我原本就打算给A1MINI设计一个收纳工具的底座，想不到已经有了，哈哈，再次感谢“JAV-3D”。Thanks to the original author "JAV-3D" designed the bottom of such an accurate model stp file, let me save a lot of manual measurement and calibration time, I originally intended to design a storage tool base for A1MINI, but I can not imagine that already have, haha, thank you again "JAV-3D! Thanks again to "JAV-3D". 注意：1.这个抽屉模型不是特别好打，面积较大而且高大，如果室温较低，很容易翘边弯曲，我自己打印就是翘边，即使pei板和模型并没有分离，但是！热床和pei板子分离弯曲了！不过貌似不影响使用，只是不够完美，有机会再重新打印。2.很可惜，由于体积稍微大了，它需要X1,P1系列的机器打印。3.建议使用petg及以上耐温材料打印；4.再组装完底部最好加上泡棉之类的脚垫（泡棉胶带也ok）Note: 1:1. This drawer model is not particularly good, the area is large and tall, if the room temperature is low, it is very easy to warp and bend, I print myself is warped, even though the pei board and the model is not separated, however! The heat bed and pei board separated and bent! It doesn't seem to affect the use though, it's just not perfect, I'll reprint it when I get a chance.2. sad