Thingiverse
Ninebot ES2 cable cover plate
von a8med
7
Downloads
5
Likes
0
Makes
This is a cover plate for the LED hole in the bottom of a ninebot ES1, ES2 ES3 and ES4 scooter.
Printed with PLA, 40% infill.
NOTE: The part is sprayed with can glue and glued on the scooter!
NOTE: The part is installed upside down in the picture, the hole will be covered if installed the right way.
Printed with PLA, 40% infill.
NOTE: The part is sprayed with can glue and glued on the scooter!
NOTE: The part is installed upside down in the picture, the hole will be covered if installed the right way.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!