Thingiverse
Ninja Fridge Magnet fixed
von seldor
58
Downloads
34
Likes
0
Makes
I wasn't able to slice the original STL as there were overlapping vertices etc.
I was able to fix it using MeshLab and 3D Builder.
From the original description:
You need a d 3.6mm x h 1.5mm round magnet
15% infill is enough (I needed a bit more to get the surface closed successfully)
no support is needed.
I was able to fix it using MeshLab and 3D Builder.
From the original description:
You need a d 3.6mm x h 1.5mm round magnet
15% infill is enough (I needed a bit more to get the surface closed successfully)
no support is needed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
