Thingiverse
Nintendo Controller Holder
por der_graue
26
Descargas
27
Likes
0
Makes
I designed this Controller Holder, cause I think it fits better than the other i Have found. Especially the rounded cable holder. The cable will have no contact to sharp edges.
And its easier to print too.
Best way to print is laying on the back, so the logo loks up.
If you like my designs, you can give me a little tip :-)
Check my other designs :-)
Best regards!
And its easier to print too.
Best way to print is laying on the back, so the logo loks up.
If you like my designs, you can give me a little tip :-)
Check my other designs :-)
Best regards!
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
