Nintendo Famicom controller cable clips

This is a cable clip for the Nintendo Famicom's controller cables, where they exit the rear of the console. I designed it because I had a famicom without any clips, but then sold it without them so I haven't bothered to print these out. Still, I'm fairly certain they will work fine because I double and triple checked all of the measurements.
The diameter of the hole for a cable is about 5mm, if you need to set a scale when 3D printing.

This is a half of a clip. Print two of them to get a complete one.

Included is the SketchUp file I made. I'd have included the hand-drawn diagrams on engineering paper that I made before starting to design it in SketchUp, but I seem to have lost it.

If you want to use this but my license terms aren't amicable enough for that, ask me and I might change it for you.