Thingiverse
Nintendo LED Switch - Holder (NOT OLED!)
by DerBuenzli
0
Downloads
5
Likes
0
Makes
Not much to say, just use your normal printer settings, I print it with 90% fill but i guess you can go with less than that.
Material is about 100g with normal support structure.
Its designet for the normal switch, not the OLED one. Because the display on the OLED one is bigger and the bottom holders overlapping it. Maybe I design a new one for the OLED version.
Material is about 100g with normal support structure.
Its designet for the normal switch, not the OLED one. Because the display on the OLED one is bigger and the bottom holders overlapping it. Maybe I design a new one for the OLED version.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
