Nintendo N64 Raspberry Pi Case

Now printable on a 150mmx150mm bed!

I wanted a cool looking Raspberry Pi case that celebrated the good times I had playing N64 with my family and friends!

This will need support for printing, but not full support. I've used Slic3r and Cura to print this successfully.
* With Slic3r I was able to produce support only for the vent pieces on the bottom by messing with the "Overhang threshold" option under Print Settings>Support Material. The rest of the bottom I printed as bridges and I just trimmed off the loose strands, much easier.
* With Cura, I used 10% grid support, but you could probably get away with 5%. If you're printing in PLA have your print fan on 100% during all bridging. Controller and cord ports on the front and back don't require support.

Note - Pictures above are from a beta version, you shouldn't have to shred parts of the inside case anymore!

Things you'll need:

- Raspberry Pi 3B

- 5V 2.5A microUSB charger for the Pi

- 32GB MicroSD card for Pi