Thingiverse
Nintendo Pro Controller D-Pad
door jamesvanboxtel
20
Downloads
25
Likes
3
Makes
This is a model to replace the stock Nintendo Switch Pro Controller D-Pad. Some pro controllers have problems with mis inputs on the DPad, this replacement DPad fixes that problem.
Print with the DPad facing down, with supports. Use a small layer height that your printer can support. I used 0.1mm on a Dremel 3D45.
After printing, clean up any sharp edges and make sure the post and bottom of the dpad don't have any defects.
Follow my YouTube video for details on installing.
https://www.youtube.com/watch?v=7wmxN9zytsY
Print with the DPad facing down, with supports. Use a small layer height that your printer can support. I used 0.1mm on a Dremel 3D45.
After printing, clean up any sharp edges and make sure the post and bottom of the dpad don't have any defects.
Follow my YouTube video for details on installing.
https://www.youtube.com/watch?v=7wmxN9zytsY
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!