MakerWorld
Other Toys & Games
Zum Modell
Nintendo Switch 2 Pro controller stand
1k
Downloads
159
Likes
584
Makes
Nintendo Switch 2 Pro Controller StandThis is based off the minimalist Switch Pro controller remix, I had to adjust this for the smaller footprint (width) of the Switch 2 Pro controller. Added a Switch 2 logo, but will also upload a profile with no logo and a further, slower to print profile with the adaptive layer settings tweaked to give a nicer top finish (that you can't see when the controller is in place!) on the curved top surfaces. The controller fits snuggly into the holder and takes up less space than laying flat. Boost MeIf you found this useful, please consider a boost as a great way of supporting creators on here. PrintingNo specific instructions here, I used a textured PEI plate and PLA. The profile attached will give a decent print with no supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
