Nintendo Switch Dock Cover Remix Squared

This is a remix of a remix. The original (https://www.thingiverse.com/thing:2176332) had four screw posts, so the first level remix added two more screw posts and shored them up a bit. When I went to put it on the face of my dock, my screws slid right into the posts. The holes printed too big for me. So this remix is just making those screw post holes have a slightly smaller diameter. And I mean slightly. By like 0.2mm.

I also had a problem with the LED circuit board staying in, so I made that slot a little smaller, but it may be too small, as I had a little trouble getting the board in there. But now it works great.

Please do take a look at the original and the first level remix. I'm sure a lot of effort went into both. I would not have been able to design something like this myself. All I did was make a few smaller circles and extrude what was left.