Thingiverse
Nintendo Switch Folding Stand
por jd52wtf
148
Descargas
122
Likes
1
Makes
Early version of folding stand design for the Nintendo Switch. This requires an M4 X 20mm screw to fasten. Holds the Switch far enough off the table to allow for the charging connector to be attached while it is being played. Includes a pass through for the power cable to the rear.
Further refined version without the watermark can be purchased here.
https://www.etsy.com/listing/503618326/nintendo-switch-folding-stand-highly
Further refined version without the watermark can be purchased here.
https://www.etsy.com/listing/503618326/nintendo-switch-folding-stand-highly
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
