Thingiverse
Nintendo Switch OLED Dock riser lay down 15deg
von GRay_111111
8
Downloads
4
Likes
0
Makes
Basic riser for the Switch dock.
allows you to lay the dock won at angle, (eg for when storing in a cupboard etc and do not have enough vertical space to get the console in and out easily)
Print in whatever material you like,
I used transparent PLA, 1.2mm walls 10% infill.
Easy print, should take 30-40 minutes for a pair.
I guess I should fit the original dock, but I only have the OLED at the moment.
allows you to lay the dock won at angle, (eg for when storing in a cupboard etc and do not have enough vertical space to get the console in and out easily)
Print in whatever material you like,
I used transparent PLA, 1.2mm walls 10% infill.
Easy print, should take 30-40 minutes for a pair.
I guess I should fit the original dock, but I only have the OLED at the moment.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
