Nintendo Switch Screen Protector Guide
by KBilly1313
7
Downloads
8
Likes
0
Makes
Nintendo Switch Screen Protector Application Guide or Jig
Just a quick design to help when applying a screen protector to the Nintendo Switch. Hope this will save others the headache of misaligned screen protectors. Enjoy!
This was printed on a Prusa i3 MK3S using PLA at 0.2mm Layer Height and 10-15% infill to support bridging. No supports needed, runtime was a little over 30 mins.
Version 2 (V2) includes additional end tabs for better seating on the switch during application.
Just a quick design to help when applying a screen protector to the Nintendo Switch. Hope this will save others the headache of misaligned screen protectors. Enjoy!
This was printed on a Prusa i3 MK3S using PLA at 0.2mm Layer Height and 10-15% infill to support bridging. No supports needed, runtime was a little over 30 mins.
Version 2 (V2) includes additional end tabs for better seating on the switch during application.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
