Thingiverse

Nintendo Switch

by Robotobi

537 Downloads

640 Likes

12 Makes

Go to Model

You already know what you are doing on the third of March?
Yes? Then this could be something for you. :-)

1:1 scale (Original size)
You can illuminate the screen with Led's

___

#####There are two Joycon versions:

-One with a bare joycon body and separated buttons. This version is marked with a “-x-“ in the filename.
-A solid one with buttons and Joycon body in one piece. ( -z- )

#####There three console versions:

-A two-part model that you can use with LEDs. ( -y- )
-A solid single piece model. ( -w- )
-A solid two-piece model for smaller 3d printers. ( -k- )

___

#####** Instructions**
- Print with infill, no support.
- Glue the parts together.
- Print "screen.pdf", cut it out and stick it to the front of the console
If you use LED’s, I recommend to print the "screen.pdf" twice and glue one on top of the other.

- #####Upload a photo and enjoy the anticipation!

if you have any suggestions for improvement, questions or need further

breath of the wild controller Gamepad Joy-Con Joycon joy con LED led strip nintendo nintendo switch Super Mario Zelda breath of the wild controller Gamepad Joy-Con Joycon joy con LED led strip nintendo nintendo switch Super Mario Zelda breath of the wild controller Gamepad Joy-Con Joycon joy con LED led strip nintendo nintendo switch Super Mario Zelda

Source

Thingiverse

What you need to print this: Beginner Low confidence

Why?

print-in-place design · no supports

Support-free Print-in-place

Supports 0/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 1/3

Printer