NO SUPPORT Phone Stand

Had been needing a phone stand that could accommodate a variety of phones as I was printing a batch of about 20 to give as gifts but the ones I was finding all required the use of lots of support material which just wastes material and increases print time. As well as this, the ones I was finding would only accommodate certain phones in certain cases. So, I gave in and just designed one from scratch. The stand I designed uses oval shaped holes so that it does not need support anywhere, as well as being big enough to properly hold larger phones. I designed the area that holds the phone to be bigger so that phones with thicker cases can fit in it properly as well as making the hole big enough so that cases with dust covers for the charging port may fit. The charging wire run through hole is just big enough to accommodate most USB cables but if yours does not fit then just feed it through the opposite charging port side. The STL I am posting has the stand at 80 mm thickness but if you hav