Thingiverse
NodeMCU Box
von scottpreston
7
Downloads
3
Likes
0
Makes
Built this box to house my NodeMCU and mount a DHT-22 temperature sensor on the outside.
This is for the V2 of the ESP8266 ESP-12E Development Board.
I hot glued the board to the top part, it fits right in. Just a few little dabs of glue over the holes to keep the board in place. Slide in and snap together.
This is for the V2 of the ESP8266 ESP-12E Development Board.
I hot glued the board to the top part, it fits right in. Just a few little dabs of glue over the holes to keep the board in place. Slide in and snap together.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
