Thingiverse
noise reduction nut
von TMesple
1
Downloads
0
Likes
0
Makes
print this in rubber or extensible filament.
Put nuts on each side of screw for the stepper motors if you have screws long enough ( need to add 3 mm )
If you use the same screw use only one nut between stepper motor and support
No cost way to reduce the noise !
Put nuts on each side of screw for the stepper motors if you have screws long enough ( need to add 3 mm )
If you use the same screw use only one nut between stepper motor and support
No cost way to reduce the noise !
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!