Thingiverse
Nokia 5 TPU Case Shell
von Rec0iL_One
10
Downloads
17
Likes
0
Makes
Drawn up in Fusion.
Print with TPU
20% infill is totally fine,
Use Supports if you want nice looking holes.
Tree supports recommended as they leave no marks on the bottom side.
Have fun
EDIT: Added V2 i opened up the USB hole a little bit wider to also make room for the microphone, since it was partially covered.
Print with TPU
20% infill is totally fine,
Use Supports if you want nice looking holes.
Tree supports recommended as they leave no marks on the bottom side.
Have fun
EDIT: Added V2 i opened up the USB hole a little bit wider to also make room for the microphone, since it was partially covered.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
