Thingiverse
NooElec SDR tripod bracket
von on2on
2
Downloads
2
Likes
0
Makes
Remix from original for sliding in a NOOELEC SDR inside and mounting it on a Tripod.
This way an antenna can be attached directly to the SDR (small yagi or bi-quad 23 cm)
NOOELEC is a tight fit, so no screws or other needed.
Printing :
no special requirements, outside use best pet-G or better.
Print vertically gives better printing of the thread for tripod screw.
This way an antenna can be attached directly to the SDR (small yagi or bi-quad 23 cm)
NOOELEC is a tight fit, so no screws or other needed.
Printing :
no special requirements, outside use best pet-G or better.
Print vertically gives better printing of the thread for tripod screw.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!