Thingiverse
Nosey Cup
von aldabest
3
Downloads
6
Likes
0
Makes
This is a nosey cup.
A speech therapist asked me if thingiverse had a nosey cup and there was none, so I made one. It is for people with dysphagia and others who cannot bend their neck for drinking.
Print this with two walls, 0.2mm layer height, 100% infill
For waterproof-ness and food safety-ness, coat the cup with a food safe polyurethane coating.
If you are planning on using this with hot liquids, print this with a heat-resistant PLA and anneal the cup. General procedure: heat oven up to 90 C and hold for 1 hour. Place the cup on a pan and put it into the oven for 1 hour. Turn the oven off and leave the cup until the oven has cooled down to room temperature.
A speech therapist asked me if thingiverse had a nosey cup and there was none, so I made one. It is for people with dysphagia and others who cannot bend their neck for drinking.
Print this with two walls, 0.2mm layer height, 100% infill
For waterproof-ness and food safety-ness, coat the cup with a food safe polyurethane coating.
If you are planning on using this with hot liquids, print this with a heat-resistant PLA and anneal the cup. General procedure: heat oven up to 90 C and hold for 1 hour. Place the cup on a pan and put it into the oven for 1 hour. Turn the oven off and leave the cup until the oven has cooled down to room temperature.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!