Thingiverse
Nosfet Apex - Pedal Inserts
door Rawnei
1
Downloads
2
Likes
0
Makes
2025-11-07: Made the inserts slightly thicker and more robust.
2025-10-18: Minor update, reduced the material that protrudes below the pedal, otherwise everything is the same.
Make your Nosfet Apex pedals grippier with these simple inserts.
The inserts clip into the holes of the pedals and have standard 4mm threaded holes so that you can screw on anything you like, anything from mountain-bike studs to grub screws of preferred length can be installed and then you will have an additional 8 grippy studs per pedal, no need to buy expensive pedals just to add some grip.
Print them in a rigid material and print 2 of each, I printed mine with PLA+, they are not load bearing so don't need to be super strong.
My print settings:
Nozzle Size: 0.6
Layer Height: 0.25mm
Line Width: 0.5mm
Walls: 2
Top/Bottom: 10
Infill: 100% Lines/Rectilinar
Supports: Tree Support
2025-10-18: Minor update, reduced the material that protrudes below the pedal, otherwise everything is the same.
Make your Nosfet Apex pedals grippier with these simple inserts.
The inserts clip into the holes of the pedals and have standard 4mm threaded holes so that you can screw on anything you like, anything from mountain-bike studs to grub screws of preferred length can be installed and then you will have an additional 8 grippy studs per pedal, no need to buy expensive pedals just to add some grip.
Print them in a rigid material and print 2 of each, I printed mine with PLA+, they are not load bearing so don't need to be super strong.
My print settings:
Nozzle Size: 0.6
Layer Height: 0.25mm
Line Width: 0.5mm
Walls: 2
Top/Bottom: 10
Infill: 100% Lines/Rectilinar
Supports: Tree Support
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
