Thingiverse
Notebook Camera Mount for 7mm build plates
von Hazbah
0
Downloads
0
Likes
0
Makes
**UPDATE** Due to already crashing my printer into the camera at full speed breaking the lens off my camera, I have modified this to reduce crashes as much as possible. Please see the revised version in the remixes!
Just a simple Camera mount to fix the below camera to the build plate of my CR10 and keep the cable out of harms way. I am using this camera with OctoPrint on my Raspberry Pi 5.
https://www.aliexpress.com/item/1005005249688226.html?spm=a2g0o.order_list.order_list_main.11.3f28180231GSYR
It is just clamped to the build plate (7mm thick) using some 25mm Binder/Bulldog Clips. Secure enough to hold the camera steady, but hopefully not too tight so that it can come off if I accidentally crash the print head into it!
If I were to redo this, I would maybe move it another 10mm further away to give a bit more clearance just to make sure I'm using as much of the build plate as possible.
I have Printed it in PLA which I'm hoping will last reasonably as the clamping action is done
Just a simple Camera mount to fix the below camera to the build plate of my CR10 and keep the cable out of harms way. I am using this camera with OctoPrint on my Raspberry Pi 5.
https://www.aliexpress.com/item/1005005249688226.html?spm=a2g0o.order_list.order_list_main.11.3f28180231GSYR
It is just clamped to the build plate (7mm thick) using some 25mm Binder/Bulldog Clips. Secure enough to hold the camera steady, but hopefully not too tight so that it can come off if I accidentally crash the print head into it!
If I were to redo this, I would maybe move it another 10mm further away to give a bit more clearance just to make sure I'm using as much of the build plate as possible.
I have Printed it in PLA which I'm hoping will last reasonably as the clamping action is done
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
