Notebook Stand / Laptop Stand

Here is a notebook stand with a spacious tray underneath in DIN A4 size. I have divided the notebook holder into 4 parts, so you can lay the outer sides on the print bed.This results in a more uniform appearance, enhancing the overall look of the shapes,and all outer sides will have the grain of the print bed. Dimensions: Width: - outer 34 cm - inner 32 cmDepth: - outer 23.50 cm - inner 22.50 cmHeight: - rear 15.50 cm - front 6.50 cm Surface for the notebook:25 cm deep and 34 cm wideThe 3 surfaces are each 1 cm wide (left, right, and top)The slope of the surface rises at an angle of 25 degrees. I simply glued the two parts together with super glue; you probably can do a better job than I did ;) I used regular PLA.